Hollow Twill

You should be seeing the kumihimo braid design tool here.

If you are seeing this text after the page has finished loading, either javscript is disabled or your browser does not support some features required.

DMC code:

About the braid

This braid makes a hollow tube with the stitches crossing in a twill pattern. The 8 thread version has a square cross section, but the larger numbers of threads give a braid that can be squashed flat. The diagram above shows how the braid would look if you were able to cut along its length without it falling apart!

How to use the designer

Use the colour picker to choose your thread colour. If you use it on the braid, it will be added to your colour list so you can easily choose it again. Click on the thread you want to colour in the braid diagram.

Some braids allow you to change the number of threads. If available, you can use the "+" and "-" buttons to change the number of threads - active internet connection required.

How to make the braid

To make your braid, set up the threads as shown. I have given more than one way of making this braid for some thread counts - these may have a different starting position to the one shown with the designer, so check the colours on the sequence diagram before you start.

Examples of this braid can be found in:
  • Creative Kumihimo by Jacqui Carey (braid 16T) 16 threads
  • Creative Kumihimo by Jacqui Carey (braid 8H) 8 threads
  • Braids: 250 Patterns from Japan, Peru and Beyond by Rodrick Owen (braid 50) 16 threads
  • Braids: 250 Patterns from Japan, Peru and Beyond by Rodrick Owen (braid 10) 8 threads
  • Comprehensive Treatise of Braids (vol 1 - marudai) by Makiko Tada (braid 11) 8 threads
Posted on
 
 

Comments will be strictly moderated. Only comments about making this braid will be approved.

4 thoughts on “Hollow Twill

    • You can make this braid any size you want – it will depend on how thick your threads are e.g. how many strands if you are using silk or stranded embroidery floss) and how many threads you have. Experiment!

  1. Can you provide more info about the alternative method of leaving the middle threads and only moving the left/right threads? Where do you move the left/right threads to?

    • Sorry I have taken so long to reply to this. I started an answer, then realised that the diagram I was going to refer you to is wrong (and it is taking longer than I expected to get access to the tools I need to fix it). The short answer is that I was describing how to change the start position of the braids ready for the alternative method, not how to make the braid. The longer answer will come when I have fixed the diagram and can explain it better.

Leave a Reply

Your email address will not be published. Required fields are marked *